Den-Mat Sapphire Betreibershandbuch PDF herunterladen (Seite 18)

STM 3W Diode Laser Mode (continued)

The STM 3W Diode Laser unit may be deactivated at any time by

pressing the Emergency “STOP” button on the STM 3W Diode

Laser unit control panel. This action deactivates the unit function

in any mode, at any power setting, and whether or not the Laser

working power is active. To reset the unit for use, depress and

hold down the “STOP” button for 5 seconds; this places the unit

in STAND-BY Mode.

Sanitizing & Sterilizing

Sterilizing The Whitening Crystal

Clean with a mild, non-abrasive, liquid soap and thoroughly dry all surfaces. Cold sterilize with solutions

containing glutaraldehyde, low concentrations of hydrogen peroxide, isopropyl alcohol or other disinfectants

containing mostly inert ingredients.

Sterilizing The Curing Tip

Clean the tip regularly with composite solvent. The removable tip must be sterilized using standard autoclave

procedures for stainless steel instruments (135º C). Use a sterilization bag and leave sealed for future use.

Failure to sterilize tips between patients increases the risk of patient-to-patient infection.

Sterilizing The Single Use/Disposable STM Tip

Cold sterilize with solutions containing glutaraldehyde, hydrogen peroxide, isopropyl alcohol or other

disinfectants containing mostly inert ingredients.

CAUTION: DO NOT AUTOCLAVE THE LIGHT GUIDE!

Sanitizing The Light Guide and Handle

The light guide cannot be autoclaved. It should be sanitized by using a non-abrasive disinfectant. Do not use

glutaraldehyde-type disinfectants.

Cleaning The Sapphire Plus System

NOTE: Unplug the power cord prior to cleaning with any liquid. Allow the system to cool prior to cleaning.

Avoid spilling any liquid on the system. Do not use ﬂammable liquids to clean the main system or light guide.

If the internal electronics are exposed to any liquid, disconnect the power. Do not attempt to start the system.

Contact the factory for instructions at 1-800-445-0345.

Clean the main system by using a mild, non-abrasive disinfectant. Do not saturate the control panel with liquid.

Wipe with a damp towel and dry completely.

Replacement Parts

Additional tips, shields, and curing rings, light guides and lamp modules are available from Den-Mat

Holdings,

LLC. See back cover for ordering information.

Sapphire

Plus STM control panel showing

that the laser is emitting in CW at 0.8 W

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Den-Mat Sapphire Betreibershandbuch Seite 18